$1.00 – $8.00 per metre
We supply rubber for a variety of joiners
A) Large wedge (6mm width)
B) Medium wedge (5mm width)
C) Small wedge (4mm width)
D) Very small wedge (3mm width)
E) Extra small wedge (2mm width)
F) Butterfly seal with hard base
G) Tube seal with hard base
H) Butt rubber for jointer side edge
I) U rubber seal for end/edge capping
Note: The wedge sizes above are the gap prior to compression. The fins will squeeze into a gap 1-2mm less than the above measurement. For example: if you have a 3mm gap you would use a B) wedge.
For Freight charges please contact Supreme Plastic Roofing on 09 636 0949
Twinwall – It is very important that you keep the flutes dry. Please make sure that you keep your twinwall in a covered area away from water (moisture) and dust until installed correctly
Acrylic – Please keep the acrylic in a dry area as the sheet comes with a paper masking which is very hard to remove if wet.
Custom Glaze – Do not leave your sheet out in the sun as the protection cover can bake into the sheet. Keep undercover until installed.
