Polycarbonate twin wall joiner
- 2 piece joiner, 60MM width over all.
- Bottom piece is fixed to the rafter, top piece clips down to hold sheet in place.
- Will work with both 6MM & 8MM and must be fixed to and existing rafter.
- 25MM gap in the centre, must allow 30MM when joiners two sheets together to allow for thermal expansion.
- Only for use with Twin wall polycarbonate
Freight Information
For Freight charges please contact Supreme Plastic Roofing on 09 636 0949
Storage Information
Twinwall – It is very important that you keep the flutes dry. Please make sure that you keep your twinwall in a covered area away from water (moisture) and dust until installed correctly
Acrylic – Please keep the acrylic in a dry area as the sheet comes with a paper masking which is very hard to remove if wet.
Custom Glaze – Do not leave your sheet out in the sun as the protection cover can bake into the sheet. Keep undercover until installed.
